mikesmarinefiberglassrepair.com

So its May I started a Nitro 2011 A Z-7 May 2 /21First I cover all boats .A chip , nice ah ?I try too block this scratch off , but its too deepdoesnt like much , but I have a baseHere where I repaired an flake an clearcoat the deep scratch , letting this dry , until tomorrow 5/3I did the body work an a couple of other things , an shot the flake an clearcoat on 5/3/21RefinishAnother fine job flake boat 5/5/21

I got a Mako in today Bob's Boat5/12 doing touch upsA chip on the back .............an the boat is cover.........I have a air void too repair Before an afterChop an ready too fill ...........Before an afterThere is 2 down here .......................Than after I uncover the front I found 7 holes from old equipement , I called the owner an add on the cost was okTape off an ready too be filled ..............5/12/21All 7 holes are gone 5/14/21Reblock to get the boat higher too wet sand buff 5/15/21Got it .........  Finish an who next   ...............5/15/21

Yes I started doing the Nitros an Randers here a Ranger that Pete came over with first there is some scratchesandthese , an the big chip on the corner threw 3 colorsI have the boat coverSo I wet sanded the scratches off 5/8/21an these scratches are wet sanded flat smoothya it looks funny , but this is the base for this repair , I will block this flat an than do the next part............... 5/8/21Block sanded and tap up ready for flake an clearcoatTouch up flaked and clearcoated , letting it dry .5/8/21I tape off the red flake it , clearcoated an untape it  an clearcoated the black part again .5/9Getting the grey flake part ready too sprayed 5/10/21Check it out , letting it dry , chip is goneLetting it dry 5/10/21ready too wet sanded and buffChip and scratches are gone 5/11/21The Ranger flake job is Done . Pete , check it out ?